AddExtrudedGeometry

Oct 28, 2013 at 3:52 PM
Can you provide an example with meshBuilder.AddExtrudedGeometry?
I tried to use it, but with no success. Instead, the ExtrudedVisual3D works fine.

Thanks,
Giovanni
Dec 20, 2013 at 8:31 PM
anyone?
Coordinator
Jan 7, 2014 at 10:34 PM
It is possible this is an obsolete method. (The MeshBuilder needs some refactoring)
Can you use the AddTube method? It can take a general section.
Jan 8, 2014 at 2:15 AM
Good to know!
Yesterday I wanted to check it out for Rinaldin but even though params were logically correct the mesh was wrong.
All the faces were compressed to a single plane that seemed to be defined by the first pair of points in the section.
Coordinator
Jan 8, 2014 at 7:30 AM
Second thought: it would be good to have the AddExtrudedGeometry method too. I see the intention was to extrude a section between two points which is much simpler than making a tube. I have added an issue: https://helixtoolkit.codeplex.com/workitem/10012